Commercial
Commercial Glass & Storefront Door Repair
A storefront door opens a few hundred times a day and then has to seal against a Maine February. When the closer goes, it stops being an inconvenience and becomes a door that will not secure at close of trade.
The short answer
Closers slow down in the cold. Hydraulic fluid thickens, and most commercial doors need a seasonal adjustment nobody makes.
Securing comes first. If you cannot lock up tonight, that is the job before anything else.
Historic frontages get repaired in keeping. Not swapped for aluminium.
How a storefront door works
Six parts under several hundred cycles a day
Commercial hardware is not weaker than domestic hardware. It is doing far more work, in a climate that makes the work harder.
Part 01
The closer
A hydraulic arm that controls how the door shuts. It handles hundreds of cycles a day, and when it fails the door either slams or stops latching — and a door that does not latch does not lock.
Part 02
The pivots
Top and bottom pivots carrying a narrow-stile aluminium door. As they wear the door drops, catches the threshold and starts racking the corners.
Part 03
The corner joints
Aluminium doors are tie-rodded together at the corners. Once a door has been dragging, those joints loosen and the leaf goes out of square.
Part 04
The threshold and sweep
On a Maine shopfront this takes salt, sand, meltwater and several hundred pairs of boots a day. It wears faster than anything else on the door.
Part 05
The glazing
Large tempered panes in high-traffic positions, always made to size. Securing comes first and glazing follows.
Part 06
The rear service door
Usually a steel door that has been kicked, forced and weathered, and usually the security weak point of the whole building.
Worth doing first
What to deal with first on a commercial frontage
Ordered by consequence to the business rather than by what is most visible.
Anything that stops you locking up
A closer or latch that leaves the premises insecure at close of trade is not maintenance. It gets done today.Everything else can wait for this.
The closer, before winter
Hydraulic closers stiffen as temperatures drop. A closer that is marginal in October will not latch the door in January.The single most seasonal item on a Maine shopfront.
Worn pivots
A dropped door catches the threshold, racks its corners and eventually needs rebuilding rather than adjusting.Catching it early saves the leaf.
Threshold and sweep
Salt, sand and meltwater at the entrance of a Maine business destroy these faster than anywhere in the building.Cheap, and it keeps the floor dry.
Glazing and frontage repairs
Important, but rarely as urgent as the hardware, and glass is made to size regardless.Plan it rather than rush it.
The honest comparison
Repair the frontage, or replace it
Replacing a commercial entrance is a significant job. Most of the time the hardware is what failed.
Repair
Almost always
- The closer, pivots or locks have worn
- The door has dropped but the leaf is sound
- Corner joints loosened and re-tensionable
- Threshold and sweep worn out
- Glazing broken in an otherwise sound frame
- A historic frontage worth keeping in keeping
Replace
Occasionally
- The leaf is bent or the corners are beyond re-tensioning
- The frame has been forced out of square
- Corrosion through the bottom rail of the door
- A frontage being reconfigured for other reasons
We are not an access-control or automatic-door contractor, and we will say so rather than improvise. Powered operators, certified exit hardware and alarm integration are specialist trades.
Maine conditions
What Maine asks of a commercial opening
Cold hardware, salt underfoot, historic frontages and a short season to do exterior work.
Cold changes how a closer behaves
Hydraulic fluid thickens as temperature drops, so a closer tuned in summer closes slowly or incompletely in winter. That is a latching failure, and therefore a security failure. Seasonal adjustment is routine maintenance that almost nobody does.
Salt and sand at the entrance
A Maine shop entrance takes months of treated grit walked across it. It wears thresholds and sweeps, corrodes bottom rails, and gets into every pivot and track on the frontage.
Historic Main Streets
Portland's Old Port, Bath, Camden, Belfast, Hallowell and a great many Maine downtowns hold original timber and cast-iron shopfronts in districts where exterior work is reviewed. Repair in keeping is usually both the right answer and the permitted one.
A short exterior season
Glazing and frontage work in Maine has a sensible window, and it is not February. Anything that can be planned for autumn is work that does not have to be improvised in a cold snap.
Not worth your money
Four things businesses waste money on
Three of these cost more later and one is just a false economy.
×
Propping a door that will not close
It solves today and destroys the closer, the pivots and eventually the leaf. It also leaves the premises unsecurable.
×
Replacing a closer that only needed adjusting
Many closers that appear to have failed in December are simply set for summer. Adjustment is a fraction of replacement.
×
Ignoring a dropped door until it drags
Once the leaf is scraping the threshold the corners are already working loose, and the repair moves from pivots to rebuilding.
×
Replacing a historic frontage with aluminium
In a Maine downtown that is often not permitted, frequently more expensive once the review is factored in, and almost always the wrong call commercially.
Coverage
Commercial glass and storefront door repair across Maine
A mobile service covering the whole state, from the southern coast to Aroostook. Pick your town below, or call and we will come to you.
Commercial Glass & Storefront Door Repair Across Maine
Questions
Commercial questions
Our front door will not latch properly in winter.
Most likely the closer, not the lock.
Hydraulic closers stiffen in the cold and stop driving the door fully into its latch. Seasonal adjustment usually solves it, and it is far cheaper than a replacement.
Can you come out after hours?
Where the job requires it, yes.
Securing work happens whenever it needs to. Planned repairs we fit around your trading hours, including early, late or on a closed day.
Do you do automatic doors or panic hardware?
No, and we will tell you so.
Powered operators and certified exit hardware are specialist trades. On something this consequential we would rather point you to somebody than improvise.
Our building is in a historic district.
Then repair is usually both right and permitted.
We work in keeping with the frontage rather than replacing character elements with modern substitutes.
Can you glaze a shopfront the same day?
Securing yes, glazing rarely.
Commercial tempered glass is made to size. We secure the opening the same visit and give you an honest date for the permanent pane.
Do you invoice businesses properly?
Yes.
Written itemised quotes and invoices suitable for accounts, insurers or a managing agent.
Related
Other repairs we handle
Windows and doors are the whole business, so whatever has failed, it is on this list.
Next step
Your front door is the business
Free estimates across Maine, scheduled around your trading hours.